GHC715 HIGHT-resistance magnetic reader (>=2750OE) driver

1, click card.exe into

2, click on "System Settings", the right to set parameters to determine.

3, click on "establishment of communication," into a green reset button at this time that communications can build a successful card read and write operations of the. To do is, first of all choose to read and write tracks, choose the right two and three-rail track to operate

4, if only for a single card can be read the following steps, click the "reader", green light, credit card, the card shows a green light at the same time eliminate, to the next one card read, repeat the above operation .

5, and if we read more than one card you can click the "continuous reader" green constant light after credit card, after reading a replaced one.

6, for a single card to write the steps of: Choose Track, here still choose 23 tracks, click the "Write Card" is written in the 23-orbit data to be imported, and then click the "Write Card", this time yellow light, credit card, lights turned off and that action has been completed to test whether it is written is correct, according to the first four steps in reader test.

7, if a row of multiple cards can write the following steps to set up, open the "continuous writing cards" drop-down menu, click "Settings", assuming that the data is written 23 tracks, first select the two-track, write data, Click OK, select the three-track to write data

8, in the "continuous writing card Settings" dialog box during the operation of the first type "field length", and then enter the other variables.

9, the relationship among the variables as follows: length = domain domain central domain length + head + tail domain, where the data field length of track length; domain head, tail domain, respectively track the data before and after the same data length; Center field length is the length of track data changes; threshold and end, respectively for the central domain of data start and end data, the number of start and end can not be greater than the length of the central domain of length; incremental increases as the central law of domain data.

10, click OK, this time finished orbital data has been set up, you can click "Cancel" to return on an interface, select the second track, and three-rail interface appears below, where two and three-rail track data shall be set above our data.

11, this time click the "continuous writing cards" yellow light, credit card, can continuously write N cards.

12, are used up, click "Exit" to exit the software.